Global Fire Gekko - Technical Specifications

Global Fire Equipment // globalfire.pt
ma_gekko_01_010002_en_190522
NOTE:  Chameleon Communications troubleshoot and menus are mostly focused from the
“listening/receiving” path. Most of the communications faults are detected by a loss on the
receiving channel.
8-5-6 BMS Setup
This function will configure all Building Management System (BMS) Protocols available. The dedicated channel in the
GEKKO is the CH2.
The Chameleon Panels support the following BMS configuration on the CH2:
BMS
PANEL ADDRESS
CH2 PROTOCOL
SELECTION
TYPE
SPECIFIC
comments
XX
(not applied)
NONE
(not applied)
CH2 working as a normal Chameleon port
01 to 64
ODYSSEY
(not applied)
CH2 working as an Odyssey port
=> with the specified PANEL ADDRESS
XX
(not applied)
SHORT MSG
1
CH2 working as “short text” serial port
=> DECT, no fault
('B'-Alarm / 'V'-PreAlarm)
2
CH2 working as “short text” serial port
=> DECT, transmit faults
('B'-Alarm / 'V'-PreAlarm / F-Faults)
3
CH2 working as “short text” serial port
=> SafeTel, no faults
('Al'-Alarm / 'Fo'-PreAlarm)
4
CH2 working as “short text” serial port
=> SafeTel, transmit faults
('Al'-Alarm / 'Fo'-PreAlarm / 'De'-Device Faults /
'Sy'-System Faults)
8-9 Version Information
This function allows the installer to check which software version is running on the current Panel.
TECHNICAL SPECIFICATIONS
Please note that these specifications apply to the GEKKO Analogue Addressable panel, 1 to 4 loop models,
46