Gocycle G1 - Page 42

Gocycle
®
Owner’s Manual Version August 2015
© Karbon Kinetics Limited. All Rights Reserved. 39
When you plug the controller leads into the battery pack inside the frame, you will hear one beep (EU mode) or two
beeps (USA mode). This means the controller is functioning correctly.
Figure 8-5
Plug in controller by inserting
upwards into outlet, rounded
edge of plug towards front.
Figure 8-6
NOTICE ROUND EDGE OF
PLUG IS TOWARDS THE
RUBBER DUST BOOT ON
FRONT STEERER AND
FLAT EDGE OF PLUG
POINTS TOWARDS THE
REAR. INCORRECT
POSITION OF PLUG WILL
CAUSE MOTOR TO
MALFUNCTION.
Figure 8-7
Controller should be plugged
in with no more than 1mm
gap between frame body and
plug.
0mm – 1mm
mm
Rounded edge of
plug toward front
Front
Rounded edge of
plug toward front