Gocycle
®
Owner’s Manual Version August 2015
© Karbon Kinetics Limited. All Rights Reserved. 42
8.3
Empower Pack: Operation
8.3.1 Gocycle Motor Philosophy
Gocycle’s electric motor is designed to boost performance in terms of getting you from point A to point B more
quickly and with less effort.
On-demand power comes when you press the red button next to the left brake lever on the handlebar and hold it
down. When you release the button, you cut the power. We do not recommend you hold the button down while
applying the brakes—you will cut the power as you slow the Gocycle under braking, and you will cut power
completely when your speed falls below 2mph. In EU mode, the motor will not start unless you are travelling faster
than 2mph and only after you have pedalled more than 6 revolutions. In USA mode, the motor will not start unless
you are travelling faster than 2mph.
The Gocycle is supplied with the legal operating mode (EU or USA) of the country in which you purchased the
Gocycle.
8.3.2 EU Mode
In EU mode the motor will not function unless the pedals are turning AND the Gocycle is travelling at a speed
above 2mph.
When starting out from a stop or after 30 seconds of not pedalling, you will need to pedal a minimum of 6
revolutions before the motor will function.
To start the motor, simply press and hold the red power button down. If the Gocycle is moving above 2mph AND
the pedals are moving AND the pedals have moved more than 6 revolutions, the motor will start.
Power from the motor will increase as your speed increases to about 12-13mph. At this point the power will
decrease with increasing speed of the Gocycle up to 15mph when the motor will shut off completely. Pedalling
above 15mph will not allow you to have any power from the motor. This is in accordance with EU regulations.
NOTE: If you require different power performance for specialised racing or tuning, you can purchase the Gocycle
Chip Tuning Software.
8.3.3 USA Mode
In USA mode, the pedals do not have to revolve to activate power.
Power will be available at speeds above 2mph and will start to decline at speeds around 17mph (assuming level
smooth pavement), depending on the weight and size of the rider and the tyre pressure.
8.3.4 Resetting the Controller
From time to time, the controller may require rebooting—much like a PC. If it appears that the controller is not
functioning correctly, perform the following reboot sequence:
To reset to EU mode (for customers operating Gocycle within the EU): With the Gocycle at a stop
(such as with the brake held on), press and hold the red power button for 7 to 10 seconds until you
hear 1 beep, then release the button immediately.
To reset to USA mode (for customers operating Gocycle with the United States): With the Gocycle at a
stop (such as with the brake held on) press and hold the red power button for about 20 to 50 seconds
until you hear 2 beeps, then release the button immediately.
WARNING! Operating the Gocycle in USA mode is not legal on public roads within the EU. Operating
in USA mode within the EU is only legal on private property such as a racing track.
To Next Page
Loading...
