11. Repeat the process for the
other wheel on the other hub.
NB: If you do swap wheels
between hubs while riding
ensure to check the cam lever
free play again as there can be
slight differences between
front and rear hubs.
9.10.2 Fleet management and Tour Operators
If you operate a fleet of Gocycles that are lent to people who are not accustomed to the Gocycle or are running a
tour operating service with the Gocycle as the chosen vehicle we would highly recommend fitting the tamper proof
security bolts. This reduces tampering and preventing novice users from making a mistake when assembling the
product that could potentially make it unsafe to ride.
If there is a requirement to fold the Gocycle and remove the wheels during use then the importance of the pre ride
checklist must be taught to the operator of the Gocycle. Furthermore, all Gocycles must be PDI’d with cam lever
adjustments completed before each and every handover to the tourist/ fleet user.
9.11
Tyres
Gocycle comes fitted with specialised and high-performance tyres designed to give the lowest rolling resistance
possible. We do not recommend that you use lower quality tyres than those supplied with Gocycle.
We recommend that you operate Gocycle with 25-30 psi on the front tyre and 50-60psi on the rear. This will give
the best balance of low rolling resistance and comfort.
To Next Page
Loading...
