EasyManua.ls Logo

Gocycle G1 - Page 44

Gocycle G1
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Gocycle
®
Owner’s Manual Version August 2015
© Karbon Kinetics Limited. All Rights Reserved. 41
8. THE THIRD BEST PRACTICE FOR YOUR BATTERY IS TO CHARGE IT FULLY, AND THEN
UNPLUG THE CONTROLLER. YOU CAN THEN LEAVE THE BATTERY FOR UP TO ONE
MONTH BEFORE FULLY RECHARGING IT.
9. NEVER LEAVE YOUR BATTERY IN A DEPLETED OR PARTIALLY CHARGED STATE.
10. WHEN IN DOUBT, PUT THE BATTERY ON CHARGE AND LEAVE IT ON CHARGE!
Battery performance will vary from customer to customer, and there is no practical qualification on what normal
performance is and what is less than normal. Generally, if there is zero input power to the pedals you should get
more than 35 minutes of run time at 15mph on level ground in EU mode, and you should get more than 20
minutes of run time at 17mph on level ground with an 80kg rider and luggage in USA mode. Substantially less than
this run time may indicate that there is a fault with the battery. Note: at temperatures below 10 degrees Celsius,
performance of the battery may be lower than the minimums stated above. This is considered normal for the NiMh
chemistry of this battery pack.
WARNING! If you hear multiple beeps from the controller every 2 to 3 minutes, your battery pack is
dangerously low on voltage and needs immediate charging. This is the low voltage alarm alerting you
that the battery is being damaged. The controller records these low voltage alarms, and recordings of
excess alarm readings could void the warranty.
Figure 8-9
To charge the battery pack,
open the charger jack cover.
Figure 8-10
Plug in the charger and
switch it on. The charge is
complete when the green
light is solid. (Green light
flashing is nearly charged.)
Full charge takes about 3.5
hours.

Table of Contents

Other manuals for Gocycle G1

Related product manuals