Gocycle
®
Owner’s Manual Version August 2015
© Karbon Kinetics Limited. All Rights Reserved. 91
Between adjustments, check
that the rear hub rotates in
the freewheel direction. The
bearing cup nuts should be
tightened until the wheel
does not have more than
1mm of ‘free’ play at the rim,
and the wheel is able to
rotate freely. This is a matter
of compromise and feel. If in
doubt, consult KKL for
advice.
Retighten the outer lock nut.
Note: after tightening the
outer lock nut, the hub may
need re-adjusting due to the
nature of the tightening
process. You may need to
repeat this process until you
have the desired freeness of
rotation and minimal lateral
play at the rim.
Retighten the
outer lock nut.
Hold the inner nut
stationary.
To Previous Page
