Goelst G-Motion - Light Sensor

21
4
200cm
English
Programming
SET / ERASE intermediate positions
1. Using OPEN or CLOSE buttons, move the curtain in a desired position, to set a new
intermediate position or to erase an existing one.
2. Press and hold the OPEN+CLOSE buttons until the LED on the motor unit slowly ash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
3. Repeatedly press OPEN or CLOSE until the LED on the motor unit is green.
4. Shortly press the OPEN+CLOSE buttons to enter the feature menu.
5. The LED on the motor unit now ashes green, at setting 1 (1x ash):
6. Cycle through the options below using OPEN or CLOSE:
1x ash = intermediate position 1 (Default)
2x ash = intermediate position 2
3x ash = intermediate position 3
4x ash = intermediate position 4
5x ash = intermediate position 5
7. Conrm and store setting by shortly pressing OPEN+CLOSE buttons: The position is
stored as new OR as replacement in case of an existing position setting.
8. The LED on the motor unit slowly ashes white again for 15 seconds: using the
OPEN or CLOSE buttons another MENU 2 feature can be selected.
9. Otherwise, wait for 15 seconds or shortly press the OPEN+CLOSE buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To store another intermediate position, repeat § 2.2 entirely.
To quit programming at any time, repeatedly press the OPEN+CLOSE buttons or wait for 15s.
Changes made at 6 will only be saved if conrmed by pressing the OPEN+CLOSE buttons.
2.3 Light sensor
The advanced Goelst Light sensor offers
1) Sun light related sensitivity
2) Dawn/Dusk related sensitivity
3) detailed behaviour settings
Default setting for both Sun and Dawn/Dusk sensitivity is „Standard“
see § 2.3.1 and § 2.3.2
Default setting for overall behaviour is „Close at Dusk“.
see § 2.3.3.