Goelst G-Motion - Light Sensor Behaviour

24
4
Programming
English
2.3.3 Light Sensor behaviour
motor LED colour purple:
To make use of the light sensor, dene its response to Sun light signals and Dawn/Dusk
light signals. There are 8 preset patterns available.
Note: After 15s. without input, the motor unit quits programming mode.
Please read the steps of this feature rst before starting.
SET Light sensor behaviour
1. Press and hold the OPEN+CLOSE buttons until the LED on the motor unit slowly ash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
2. Repeatedly press OPEN or CLOSE until the LED on the motor unit is purple.
3. Shortly press the OPEN+CLOSE buttons to enter the feature menu,
4. The LED on the motor unit now ashes purple at the current setting:
5. Cycle through the options below using OPEN or CLOSE:
LED Dawn/Dusk Sun
OPEN CLOSE OPEN CLOSE
1x ash *)
O󰀨 On O󰀨 O󰀨
2x ash
On On On On
3x ash
O󰀨 O󰀨 On On
4x ash
On On O󰀨 O󰀨
5x ash
O󰀨 On On On
6x ash
On On O󰀨 On
7x ash
O󰀨 O󰀨 O󰀨 On
8x ash
O󰀨 O󰀨 O󰀨 O󰀨
*) Default setting
6. Conrm and store setting by shortly pressing OPEN+CLOSE buttons.
7. The LED on the motor unit slowly ashes white again for 15 seconds: using the
OPEN or CLOSE buttons another MENU 2 feature can be selected.
8. Otherwise, wait for 15 seconds or shortly press the OPEN+CLOSE buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To quit programming at any time, repeatedly press the OPEN+CLOSE buttons or wait for 15s.
Changes made at 5 will only be saved if conrmed by pressing the OPEN+CLOSE buttons.