4. Configuration Instructions
4.1 Initial Configuration
4.1.1 Power on and start
Before powering on, it is necessary to ensure that all configurations of the
server are installed in accordance with the corresponding specifications and
standards, and keep the server turned off but not unplugged from the power
supply. And all cables are connected properly, and the power supply voltage is
consistent with that of the device.
During the power-on process, please do not plug in hard drives, power
modules, network cables or other external devices and cables.
If the server has just been unplugged from the power supply, please wait for 1
minute before turning on the power.
Server power-on power status:
The power supply is powered on, but the server is not turned on, and the
power indicator is amber.
Power on, the server starts up, and the power indicator light is green.
How to power on the server:
The server's default power-on policy is "Power-On Boot," which means the
server will automatically power on when it receives power. Users can modify
this setting in the BIOS Setup interface.
Press the <DEL> or <ESC> key on the keyboard during the boot process to
enter the BIOS Setup interface, and find the following interface: