Appendix
(Common fault diagnosis)
No display after power on
Make sure the monitor cable is properly connected and the power indicator on
the monitor lights up when the monitor is powered on.
Ensure the monitor is connected to the server.
If the above steps do not resolve the issue, try replacing the monitor with a
known working one to confirm if the original monitor is faulty.
If the issue persists, please contact Gooxi technical support for further
assistance.
Front Panel Indicator Lights Alarm
Refer to the instructions in the manual to determine the specific alarm
information indicated by the front panel lights and buttons.
For power failure indicator lights alarm, check if the power module indicator
lights on the rear window of the server are abnormal. If the power module
indicator lights are normal, please contact Gooxi technical support for further
assistance. If the power module indicator lights are not normal, please ensure that
the server, power module, and power cords are functioning correctly.
For system alarm indicator lights, first check the external environment.
For other indicator light alarms, please contact Gooxi technical support for
further assistance.
Abnormal Hard Drive Indicator Lights
Ensure the hard drives are properly installed.
Refer to the instructions in the manual to determine the specific alarm
information indicated by the rear panel lights and buttons.
Confirm if the RAID card is configured correctly.
Check for any drive dropouts during OS installation. If this occurs, please
contact Gooxi technical support for further assistance.
Unable to Use RAID Card
Ensure the RAID card is properly installed.
Try reseating the RAID card and PCIe adapter to confirm if they are
functioning correctly.
To Next Page
Loading...
Need help?
General
