Grace EASY User Manual

GRACE EASY Manual
Page | 77
2. First time use
2.1. Removing/inserting the battery
Removing the battery:
Using the key, unlock the lock on the battery so that
the lock cylinder comes out.
Slide the battery along the down tube towards the
handlebars. Lift up the rear of the battery and
carefully remove it by moving it at a diagonal towards
the rear.
Inserting the battery:
Set the battery down onto the down tube. Slide the
battery along the down tube towards the bottom
bracket. Press the battery lock cylinder inside it until
it clicks into place.
If the bike shoots itself temporary
of, while riding over a bump, a readjustment of the
locking plate is necessary.
If the lock cylinder of the battery does not latch into place, this means the battery is
not secured. It will be able to fall out of the battery cradle while riding. Risk of
accident!
Always install the battery as described and make sure that the battery is latched
into place.
If the battery is not correctly fitted in the guide rails, it is not possible to press in the
lock cylinder. If this is the case, re
-insert the battery.
The lock cylinder can also be pressed in even if the key is not inserted into the lock.

Grace EASY Specifications

General

Brand	Grace
Model	EASY
Category	Bicycle
Language	English