2.4. Adjusting the saddle position and -angle
To change the angle and horizontal position of the
saddle, undo the two hexagon sockets on the saddle
clamp which are positioned immediately behind the
saddle
post above the rear wheel.
You can now move the saddle forwards and
backwards in the guide and adjust the angle.
In the basic position, the saddle should be arranged
horizontally. You may not be able to find the best
position until after
Afterwards, retighten both screws again (see torque
table).
If you place the balls of your feet on the pedal while it is in its lowest position, you
knee should be bent slightly and your kneecap should be in a vertical line to the
pedal axis.
To Next Page
Loading...
