2.10. Mounting instruction Pedal reflectors for Schindelhauer-pedals
Driving the vehicle without mounted pedal reflectors is not compliant with the
Road Traffic Licensing Regulations. For this reason, the installation of the pedal
reflectors is highly recommended.
Preparation
Make sure that all required components are available:
•
8x Cross recessed screw M4x22mm
•
8x self-locking nuts M4
•
4x Mounting wedge outside
•
4x Mounting wedge inside
•
4x Reflector housing
•
4x Reflector
•
2x Schindelhauer pedals
Have the following tools avaiable:
•
Cross screwdriver PH2
•
wrench 7 mm mouth width
Work steps
Take the reflector housing and plug the M4 screw
into the existing long holes. Then push on this the
mounting wedge.
To Next Page
Loading...
