Alternatively, the charge status of the battery can be
shown on the LED ring of the charge socket. Slowly
slide the finger across the charge socket and see the
LED ring light up a particular colour.
While the system is switched on, press the
CLOCK and the current time setting will be displayed
and the hours indicator will flash.
button to adjust the hours.
Use the
button to switch between hours and
minutes. After adjustment is complete, complete
your entry with the
button. The time is saved.
The lighting system consists of:
Headlight and rear light
white reflector in the headlight
red reflector on the saddle
reflective strips on the tyre walls
yellow reflectors on the pedals
two yellow side reflectors (S-Pedelec only)
Regularly check the safety
technical equipment and, where necessary, repair it in an
authorised workshop.
The lighting system meets the requirements of the StVZO. This registration is issued
by the Federal Motor Transport Authority and can be seen by a registration number
with a shaft line, the upper case K and a number.