Grace EASY User Manual

GRACE EASY Manual
Page | 103
5. Maintenance
5.1. Regular maintenance work
Before each ride:
 Check the wheels and tyres
 Check the drive belt
 Check the battery fitting
 Check the function and wear of the brake system
 Check screw connections
Every 300 – 500 km (186 – 310 miles):
 Check the drive belt for wear and check the tension/travel is correct
 Remove any dirt from the drive belt and timing pulleys
 Check that the screw connections sit tightly
 Measure the wear surface of the brake discs
1 x year/after 1000 km (621 miles), afterwards every 2000 km (1242 miles), by a specialist
dealer:
 Check the forks bearing, replace where necessary
 Check the wheel hubs, replace where necessary
 Check the pedals, replace where necessary
 Check the drive belt, replace where necessary
 Check the shift cable, replace where necessary
 Check the tightening torques on all screw connections
 Adjust the gear switching, check the forks bearing and brakes
 Make sure the drive belt is tensioned correctly, check for wear
 Check the wheels and tyres
 Check the stem and handlebars and heavily used parts for wear
 Check the derailleur gear
5.2. Removing/installing the front wheel
The hydraulic disc brakes must not be operated while the wheel is disassembled.
The brake pistons come together completely. Immediately after removing the
wheel, place the yellow transportation safety between the brake pads.

Grace EASY Specifications

General

Brand	Grace
Model	EASY
Category	Bicycle
Language	English