Startup
27
Startup
1. Load fluid with feed pumps
a. Check that all Setup steps are com-
plete.
b. Check that inlet screens are clean
before daily startup, page 41.
c. Check level and condition of ISO lube
daily, page 40.
d. Turn on component B agitator, if used.
e. Turn both PRESSURE RELIEF/SPRAY
valves (SA, SB) to SPRAY .
f. Start feed pumps.
g. Open fluid inlet valves (FV). Check for
leaks.
h. Use feed pumps to load system. Hold
gun fluid manifold over two grounded
waste containers. Open fluid valves A
and B until clean, air-free fluid comes
from valves. Close valves.
Do not operate Reactor without all covers
and shrouds in place.
The Reactor is tested with oil at the fac-
tory. Flush out the oil with a compatible
solvent before spraying. See page 43.
ti9877a
SA
SB
Do not mix components A and B during
startup. Always provide two grounded waste
containers to keep component A and compo-
nent B fluids separate.
FV
ti10002a
ti2484a
To Next Page
Loading...
