EasyManua.ls Logo

Graco TI12552a - User Manual

Graco TI12552a
134 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
312779E
EN
Operation
ProMix
®
2KS
Plural Component Proportioner
Automatic system for proportional mixing of plural component coatings, with Wall Mount
Fluid Station or RoboMix Fluid Station. For professional use only.
Approved for use in explosive atmospheres (except the EasyKey).
Automatic System with Wall Mount Fluid Station
Automatic System with RoboMix Fluid Station
TI12553a
TI12552a
See pages 4-7 for model information, including maxi-
mum working pressure. Equipment approval labels are
on page 3. Some components shown are not included
with all systems.
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
#53
II 2 G0359
Get other manuals https://www.bkmanuals.com

Table of Contents

Other manuals for Graco TI12552a

Preview: Repair Manual
Repair Manual82 pages
Preview: Installation Instructions
Installation Instructions56 pages

Questions and Answers

  • S
    Samuel SawyerAug 26, 2025
    Why am I getting a RATIO_HIGH_ALARM on my Graco Industrial Equipment?
    • D
      davismorganAug 26, 2025
      A RATIO_HIGH_ALARM indicates there may be too little restriction in the system. Here's what you can check: * Ensure the system is fully loaded with material. * Verify the supply pump’s cycle rate is set correctly. * Confirm the spray tip/nozzle is properly sized and not worn. * Ensure the fluid regulator is set correctly. If the alarm occurs during start-up after purging, restrict gun needle travel to slow the initial fluid delivery rate. If it occurs after spraying for some time, adjust component A and B fluid supply regulator pressures until they are about equal. Also, ensure air pressure to the valve actuators is adequate (75-120 psi, with 120 psi recommended) and that there are no restrictions in the solenoid or tubing interrupting valve actuation air.
  • D
    Donald WashingtonAug 25, 2025
    What to do if I get a potlife alarm on my Graco Industrial Equipment?
    • K
      Kylie SmithAug 26, 2025
      If the potlife time has been exceeded for the mixed material, press the Alarm Reset key to stop the audible alarm. Then, purge the system with solvent, fresh mixed material, or perform a color change. You can purge with solvent until the preset purge time is complete, switch to Mix mode and spray the required volume to restart the timer, or perform a color change.

Graco TI12552a Specifications

General IconGeneral
BrandGraco
ModelTI12552a
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals