Graef VA 804 - Page 36

Operation
36
Use the plus/minus buttons to select the individual parameters (Mode, X number,
Slices, Pattern, ... ).
Pressing the M button then takes you to the editor where you can determine the value
using the plus/minus buttons.
Pressing the reset button takes you back to the menu for the selected PLU.
PLU 1
mode stacking
quantity 2
slices 10
layout lengthwise
portion 1
X start 0
Y start 10
dist trans 0
dist lengt 100
str/min 50
thickn 10
pause 0