Connecting via AC power
1. Connect the micro-USB connector into the related port on the repeater station and connect the
other end of the power adapter into an electrical power outlet.
2. Connect the supplied Ethernet cable between the Internet port on the DP760 DECT Repeater and
the Internet port in your network or the switch/hub device port.
Connecting via PoE
To connect the DP760 DECT Repeater using PoE, you need to connect the Ethernet cable provided (or
3rd party network cable) between the Network Socket on the repeater station to Ethernet port of your PoE
switch/hub.
DP760 Implementation Architecture
The DP750 Base Station can support up to 5 DP760 DECT Repeater stations to extend the coverage area
of the base in all directions, including through floors and ceilings using star architecture as displayed on the
following diagrams.
When a repeater powers on, it searches for signals from the base and any other repeaters registered to the
same base. The repeater will automatically connect to the first available signal.
The base can hand-off calls to the repeaters as the user moves from one coverage area to another. When
connected to the repeater, the DP720 handsets operate as it is connected to the base, and the hand-off
from the base to the repeater can be completely invisible to the end user, even during an active call.
Notes:
• DP760 can relay up to 2 concurrent calls.
• DP750 will only support up to 2 concurrent calls when the repeater mode is enabled.
To Next Page
Loading...
Need help?
General