RESTORE FACTORY DEFAULT SETTINGS
Warning:
Restoring the Factory Default Settings will delete all configuration information on the repeater. Please
backup or print all the settings before you restore to the factory default settings. Grandstream is not
responsible for restoring lost parameters and cannot connect your device to your VoIP service provider.
Resetting DP760 Repeater Station
There are two methods to reset your DP760 DECT Repeater to the default settings:
Via Reset Button
1. Locate the reset hole on the back panel of your DP760.
2. Insert a pin in this hole, and press for about 7 seconds.
3. Take out the pin. The unit will restart automatically with parameters restored to default values.
Note: A quick press on the reset hole will only reboot the unit.
Via Web GUI
1. Access your DP760 DECT Repeater Web GUI.
2. Enter your admin’s username and password. (Default username and password: admin/admin)
3. Press Login to access and navigate to Maintenance Factory Reset.
4. Press Reset button and the unit will prompt a confirmation message, press OK to reset the repeater,
then the unit restart automatically with parameters restored to default values or press Cancel to
annul the reset.
To Next Page
Loading...
Need help?
General