Manual Association
To manually associate your DP760 DECT Repeater to your DP750 Base Station:
1. Access the Web GUI of your DP760 using the admin’s username and password. (Default username
and password are admin/admin). Refer to [Accessing the Web GUI]
2. Navigate to DECT General Settings and set Use Manually Configured RFPI to Yes.
3. On Manually Configured Base RFPI field, configure your DP750 Base Station RFPI address.
Note: The RFPI Address of your DP750 Base Station is available under the Web GUI Status DECT
Status Base DECT RFPI Address.
4. Click Save and Apply to confirm the new settings.
5. Go to DECT Repeater Status page and click on “Manual-Lock to xxxxxxxxxx”.
6. The DP760 DECT Repeater will automatically pair to DP750. If the association is correctly associated,
all the LEDs will remain solid on and the repeater status will be updated as following.
Figure 12: Repeater Status – Associated (Manual Association)
Note: Make sure that Repeater Mode is enabled on your DP750 Base Station.
To Next Page
Loading...
Need help?
General