Auto Association
To auto associate your DP760 DECT Repeater with DP750 Base Station:
1. Please put the DP760 DECT Repeater close to DP750, then power on the DP760.
2. After the DP760 finish booting, the association LED will be blinking to indicate that the repeater
is searching for nearby base stations.
Note: If all the LEDs remain on, it indicates that the DP760 Repeater has successfully associated with a
DP750 Base and ready for use. You may need to dissociate it before continuing (Please refer to [DP760
DECT REPEATER DISSOCIATION]).
3. Open subscription on your DP750 Base Station using one of following methods:
• Rebooting the Base station.
• Long press on page/subscribe button on the back panel of DP750 for 7 seconds.
• Access DP750 Web GUI and press subscribe button .
4. The DP760 DECT Repeater will automatically pair to DP750. Upon successful association with the
DP750 Base station all LEDs will turn ON and the repeater status will be updated as following.
Figure 11: Repeater Status – Associated (Auto Association)
Notes:
- For auto association, the option Use manually configured RFPI under DP760 Web GUI should
be disabled (by default disabled).
- The association may take up to a few minutes. Time will vary depending on the number of DP760.
To Next Page
Loading...
Need help?
General