CONFIGURATION GUIDE
The DP760 can be configured via the Web GUI embedded using a Web browser. By default, DP760 is
configured to obtain IP address from DHCP server where the unit is located and can be discovered using
UPnP feature (by default enabled).
Configuration via Web Browser
The DP760 embedded Web server responds to HTTP/HTTPS GET/POST requests. Embedded HTML
pages allow a user to configure the DP760 through a Web browser such as Google Chrome, Mozilla Firefox
and Microsoft Internet Explorer.
Note: If DP760 has a known IP, users can access to its Web GUI by entering the IP address in their Web
browser on a device connected to same network.
Accessing the Web GUI using UPnP Feature
DP760 supports UPnP feature (by default enabled) for auto discovery by computers in same network.
Please refer to following steps to access DP760 Web GUI:
1. Power on DP760 and connect it to the network.
2. Connect a computer to same network as DP760. (The computer must be connected to the same
sub-network as the DP760. This can be easily done by connecting the computer to the same hub
or switch as the DP760).
3. Access Network directory on the computer.
4. Locate DP760 - <MAC Address> device and double click on it to access Web GUI.
Figure 6: DP760 UPnP Discovery
5. Enter admin’s username and password and press Login button to access the configuration menu.
(Default username and password are: admin/admin)
To Next Page
Loading...
Need help?
General