The default setting is “Disabled”.
Allow Unsolicited REFER
Allow Unsolicited REFER to accomplish an outgoing call.
● Disabled
● Enabled
● Enabled/Force Auth
The default setting is “Disabled”.
Accept Incoming SIP from Proxy Only
When set to “Yes”, the SIP address of the Request URL in the incoming SIP message
will be checked. If it doesn’t match the SIP server address of the account, the call will
be rejected.
The default setting is “No”.
Check SIP User ID for Incoming
INVITE
If set to “Yes”, SIP User ID will be checked in the Request URI of the incoming
INVITE. If it doesn’t match the phone’s SIP User ID, the call will be rejected.
The default setting is “No”.
Allow SIP Reset
This is used to perform a factory reset through SIP NOTIFY. When the phone receives
the NOTIFY with Event: reset, the phone should perform a factory reset after the
authentication. The default setting is “No”.
Authenticate Incoming INVITE
If set to “Yes”, the phone will challenge the incoming INVITE for authentication with
SIP 401 Unauthorized response
Default setting is “No”.
MOH
On Hold Reminder Tone
If set to “Enabled”, phone will play a reminder tone when it has a call on hold.
The default setting is “Enabled”.
Music On Hold URI
Configures Music On Hold URI to call when a call is on hold. This feature must be
supported on the server side.
Advanced Features
Special Feature
Different soft switch vendors have special requirements. Therefore, users may need
select special features to meet these requirements. Users can choose from Standard,
Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro, Huawei IMS, PhonePower
and UCM Call center depending on the server type. The default setting is “Standard”.
Feature Key Synchronization
This feature is used for Broadsoft call feature synchronization. When it’s enabled,
DND, Call Forward features and Call Center Agent status can be synchronized between
Broadsoft server and phone. Default is “Disabled”.
Conference URI Configures Conference URI for N-way conference (Broadsoft Standard).
Broadsoft Call Center
When set to “Yes”, a Softkey “BSCCenter” is displayed on LCD. User can access
different Broadsoft Call Center agent features via this Softkey.
Please note that “Feature Key Synchronization” will be enabled regardless of this
setting. Default setting is “Disabled”.
Note: To activate this feature, users need to change the special feature to Broadsoft and
setup the Broadsoft Call Center to take effect.
Hoteling Event
Broadsoft Hoteling event feature. Default setting is “Disabled”. With “Hoteling Event”
enabled, user can access the Hoteling feature option by pressing the “BSCCenter”
softkey.
Note: To activate this feature, users need to change the special feature to Broadsoft and
setup the Broadsoft Call Center to take effect.
To Next Page
Loading...
Need help?
General
