Grandstream Networks GRP2636

2. Enter the number for the second call in the new line and establish the call;
3. Press TRANSFER;
4. Press the other LINE key, which is on hold to transfer the call.
When set to “Dynamic”
1. During the first active call, press TRANSFER.
2. A new line will be brought up and the first call will be automatically placed on hold;
3. Dial the number and press “AttTrnf” soft key to make a second call.
4. Press TRANSFER again. The call will be transferred.
Figure 28: Dynamic Attended Transfer

Figure 29: “Split” softkey
Clicking the Red highlighted “Transfer” Key would force a Blind Transfer.
Target Selection
Using the target selection feature, users can use the following function:
1. Add a new softkey “Target” under the transfer/conference LCD action screen.
2. When clicking on the softkey, it will take the user to a target selection page in which the user can choose other possible
transfer/conference targets (e.g. Local/BS Phonebook, Local/BS Call Logs, LDAP…)
3. When accessing the Local/BS Phonebook and Local/BS Call History page, the softkey will show limited options (e.g. Dial) if the phone is
in a busy state to make it easier for users to perform the dialing task.
4. When accessing Smart VPK List, the phone will display the list of the VPK targets which are allowed to be used as the
transfer/conference target based on the current account.
Note
Whenattended transfer is initiated during the transfer process, afterdialing out thenumber for the second call. If the second call is not
established yet (ringing), pressing “Cancel”will hang up the second call. If the second call is established (answered), pressing “Split” will resume
the second call and keep the first call on hold.