Figure 53: Line Key as Transfer Mode
LCD Indication and Configuration:
The configured fixed VPKs are displayed next to the corresponding line. If dynamic VPKs are configured, the users can see a page number
shown on the bottom left corner of the LCD.
The following figures show page 1 and page 2 of the VPKs on LCD. Pressing the “RIGHT” arrow key will switch to the next page; pressing th
“LEFT” arrow key will switch back to the previous page.
Figure 54: VPK – LCD Indication
The users could also edit and add VPK from LCD.
1. To edit (fixed) VPK, press and hold the line key for about 4 seconds, and a configuration window will pop up for the user to configure.
2. To add (dynamic) VPK, press and hold the RIGHT arrow key for about 4 seconds, and a configuration window will pop up for the user to
configure.
3. During a call, when the phone is on the call screen users can press and hold the VPK for 3 seconds to display the whole description
label, to switch back the users can wait for 5 seconds or press the VPK again.
Up to 33 modes can be supported on fixed VPK and up to 30 modes can be supported on dynamic VPK. Each mode is indicated by a
different icon on the LCD and the icon will be different when in different states.
Please find the icon indications below for different modes of VPK:
To Next Page
Loading...
Need help?
General
