Grandstream Networks GXV34 0 Series

● If set to “Call Transfer”, the phone system will pop up the “TRANSFER” key on the LCD screen when
there is an incoming call, and users could tap on it to show up the dialer without answering the
incoming call, then, users could transfer this incoming call to others.
The default setting is “None”.
Enable Conference
Enables the conference. When set to “No”, the phone will block the conference application. The default
setting is “Yes”.
Auto Conference
Allows the phone system to invite all call parties into a conference by pressing the Conf key. If it is
disabled, the end user has to add each call party to conference manually. The default setting is “No”.
Hold Call before
Adding conferee
Congures whether to place the current call on hold before adding new member(s) to a conference. If
enabled, the current call will be put on hold when the host presses Conference or Add key to invite
new member(s). When an invited member answers the call and agrees to attend the conference, the
host needs to manually resume the conference with the new member added. If disabled, the current
call will not be put on hold and the invited member will join the meeting automatically after answering
the call.
Auto Mute Mode
Congures whether to mute the call on entry automatically.
● If set to “Disable“, then do not use auto mute function.
● If set to “Auto Mute on Outgoing Call“, then mute automatically when the other party answers the
outgoing call.
● If set to “Auto Mute on Incoming Call“, then mute automatically when answers the incoming call; If
set to “Mute on Incoming & Outgoing Call”, then mute automatically when the call gets through.
Note:This function only take effect when the phone is from the idle status to call status. Users could
click the Mute button on call interface to cancel the current mute status.
Always Ring Speaker
Determines if the speaker will play the ringtone if the speaker channel is not set as default channel. If
set to “Yes”, the phone will force to play the ring speaker in speaker channel. The default setting is
“No”.
End user might need this feature when the headset is connected.
Offhook Auto Dial
Congures the User ID/extension to dial automatically when the phone is off-hook. The phone will use
the rst account to dial the congured numbers out.
The default setting is “No”.
Offhook Auto Dial
Delay (s)
Denes the timer for warm line dialing. After the timer expires, the phone system will dial the
congured number in Off-hook Auto Dial automatically. If it is not congured, the congured number
will be dialed immediately.
Off-hook/On-hook
Timeout (s)
If congured, the phone will exit the dial-up screen when timeout after Offhook or Onhook. default is
30s.
The valid range is 10-60s.
Handset Option
Congures the Handset options and can be set to:
1. If set to “Enable”:when off hook, the phone will enter into the dial screen, and the media channel
will switch to the handset; no matter if any third app is opening.
2. If set to “Disable”: The Handset will be disabled.
3. If set to “Auto”: when the 3rd-party application is calling, only the media channel will switch to the
handset when off hook; otherwise, the phone will enter into the dial screen, and the media channel
will switch to the handset.
Default setting is “Auto”.
Auto Unhold When
Pressing Line Key
Congures when there are multiple lines, whether to UnHold the line automatically when click the line
being held and hold the line in the primary call.
Note: the hold situation which is set manually will not be put on hold automatically. The default setting
is “No”.