Grandstream Networks GXV34 0 Series - Page 67

Maintenance/Upgrade/Advanced Settings
Table 42: Maintenance/Upgrade
Maintenance/System Diagnosis
Syslog
Syslog Protocol
Select the transport protocol over which log messages will be carried.
UDP: Syslog messages will be sent over UDP.
SSL/TLS: Syslog messages will be sent securely over TLS connection. To upload server CA
certificate, follow below steps:
Copy CA file in SD card and plug it to the phone.
Go to LCD menu Settings🡪Security Settings🡪Install from SD card to install the CA file.
Syslog Server
Configures the URI which the phone system will send the syslog messages to.
The default setting is “log.ipvideotalk.com”.
PNP (3CX) Auto
Provision
Sets the phone system to broadcast the SIP SUBSCRIBE message during booting up to allow itself to be
discovered and be congured by the SIP platform.
The default setting is “Yes”.
Send HTTP Basic
Authentication By
Default
Determine whether to send basic HTTP authentication information to the server by default when
using wget to download rmware or cong le. If set to "Yes", send HTTP/HTTPS user name and
password no matter the server needs authentication or not. If set to "No", only send HTTP/HTTPS
user name and password when the server needs authentication.
Enable SIP NOTIFY
Authentication
Device will challenge NOTIFY with 401 when set to "Yes"
Enabled Authentication
Server Validation
Congures whether to validate the server certicate when downloading the rmware/cong le. If
enabled, the phone will download the rmware/cong le only after the server is validated.
CA Certicate Select the CA certicate for server verication.
User Certicate
Select the user certicate to be used for mutual server authentication. If the private key is included,
upload it with the user certicate.
Enable EEE Mode
Congures enable/disable EEE (Energy-Ecient Ethernet) mode. If set to “Yes”, the phone will turn
on the EEE mode.
Note:Regardless of whether the EEE mode is turned on or off, the network will reconnect.
Default is “No”.
mDNS Override Server
Sets the phone system to broadcast the Multicast DNS (mDNS) message during booting up to
allow itself to be discovered and be congured by the SIP platform. If it is set to “User Type A’, the
phone system will broadcast the MDNS message “A_grandstream-cfg.local”; if it is set to “Use
Type SRV”, the MDNS message will be “SRV_grandstream-cfg.local”.
The default setting is “Use Type A”.
Factory Reset Resets the phone system to the default factory setting mode.