Figure 17: Active connections
Figure 18: Active Unix Domain Sockets
SYSTEM SETTINGS
This chapter explains configurations for system-wide parameters on the GXW450X. System settings are under the “System Settings” tab on GXW45
Web GUI. System settings include Network Settings, Security Settings, HTTP Server, Email Settings, Time Settings, OpenVPN® settings, and DDNS
Settings
HTTP Server
The GXW450X embedded web server responds to HTTP/HTTPS GET/POST requests. Embedded HTML pages allow the users to configure the gate
through a Web browser such as Microsoft IE, Mozilla Firefox, and Google Chrome. By default, the Gateway can be accessed via HTTPS using Port 8
(e.g., https://192.168.1.50:8089). Users could also change the access protocol and port as preferred under Web GUI🡪System Settings🡪HTTP Ser
Basic
Settings
Redirect
From Port
80
Enable or disable redirect from port 80. On the gateway, the default access protocol is HTTPS and the default port number is 8089
When this option is enabled, the access using HTTP with Port 80 will be redirected to HTTPS with Port 8089. The default setting is
“Enable”.
Protocol
Type
Select HTTP or HTTPS. The default setting is “HTTPS”. This is also the protocol used for zero config when the endpoint device
downloads the config file from the GXW450X.
Port Specify the port number to access the HTTP server. The default port is 8089.
To Next Page
Loading...
Need help?
General
