This section documents significant changes from previous versions of GXW450X user manuals. Only major new features or major document updat
listed here. Minor updates for corrections or editing are not documented here.
Added new option “Original Called” when using SS7 signaling type. [Original Called]
Added support for “early ACM” in SS7 interface settings. [Early ACM]
Added new option PROGRESS to the Edit Digital Port. [PROGRESS]
Added auth-user and auth-pass parameter support in OpenVPN. [User authentification]
Added ability to provision TR-069 settings. [TR-069]
Firewall rules will now apply to traffic between LAN and WAN interfaces. [Static Defense]
Added E1/T1/J1 Error Code option to allow users to send either 480 or 503 response to the VoIP trunk when the E1/T1/J1 interface is down or
unavailable. [E1/T1/J1 Error Code]
Firmware version 1.0.1.9
No major changes
Firmware version 1.0.1.7
Added the ability to customize call failure tone settings. [Call Failure Tone Settings]
Added ability to group E1 lines with a single DATA channel. [Data channel]
Added the ability to assign channel groups. [Digital Hardware Configuration]
Added T1 E&M signaling support. [Table 30: Digital Hardware Configuration Parameters: T1 – E&M Immediate]
Added Secondary SIP Server option to Register SIP Trunks. [Secondary SIP Server]
Added Secondary Outbound Proxy option. [Backup Outbound Proxy]
The administrator-level users can now view the SNMP page. [SNMP]
Added GDMS support.
Firmware version 1.0.0.35
Added ability to select a different E1/T1 port to use for the line’s data channel when SS7 is selected as the signaling type. [Data channel]
Added ability to select the minimum and maximum TLS versions to support. [TLS Security]
Added SNMP support. [SNMP]
Added options From User, Send PPI Header, PPI Mode, and DOD as From Name. [Table 33: VoIP Trunk Configuration Parameters – Register SIP
[Table 34: VoIP Trunk Configuration Parameters – Peer SIP Trunk]
Firmware version 1.0.0.29
Added the ability to configure tone region. [Tone Region]
Added the ability to configure DODs for VoIP trunks. [Direct Outward Dialing (DOD)]
Firmware version 1.0.0.27
Added GAPS provisioning support.
Added the Set Caller ID option to the Edit Inbound Rule page. [Set Caller ID Info]
Added the Enable Filter on Source Caller ID option to the Edit Outbound Rule page. This option will allow only callers with the specified CID p
to use the outbound route. [Enable Filter on Source Caller ID]
Firmware version 1.0.0.24
To Next Page
Loading...
Need help?
General
