IP Address The IP address of the SNMP trap receiver.
Port Configure the SNMP trap receiver listening port.
Community
Community is by default set to Public, as community strings for SNMP v1 and v2 aren’t
encrypted.
Type
They are 3 available types:
Trapsink: to send SNMP v1 traps
Trap2sink: to send SNMP v2 traps.
Informsink: to send inform notification.
SNMP V3 Users
Name Configure the Name of the SNMP v3 Users.
Authentication Protocol Authentication Protocol for SNMPv3. Available protocols are MD5 and SHA.
Authentication Password Authentication Password for SNMPv3.
Privacy Protocol Privacy protocol for SNMPv3. Available protocols are: DES, AES-128, AES-192, AES-256
Privacy Password Privacy password for SNMPv3.
Group Level
Configure the group level, two levels are available:
Read only: Can view the device configuration.
Read/Write: Can view and change the device configuration.
SNMP Trap Proxy (GXW450x as Trap Proxy)
Name
Configures the Name of the SNMP Trap Proxy.
Note: “Enable SNMP Trap Proxy” needs to be toggled on.
IP Address Configure the IP address of the SNMP manager.
Port Configure the SNMP manager listening port.
Table 24: SNMP Parameters
TR-069
The GXW450x series supports TR-069 for remote management of equipment by service providers, reducing on-site visits and downtime.To configu
SNMP settings, go to GXW450x Web GUI→System Settings→SNMP.
Note
The SNMP page can be viewed by the Administrator level users.
To Next Page
Loading...
Need help?
General
