LAN (when “Method” is set to “Route”)
DHCP Server
Enable or disable DHCP server capability. Available options are:
Disable: DHCP Server will be disabled
Auto: Stateless address auto-configuration using NDP protocol
DHCPv6: Stateful address autoconfiguration using DHCPv6 protocol.
The default setting is “Disable”
If “DHCP Server” is set to “Auto” or “DHCPv6”
DHCP Prefix
Enter DHCP Prefix when static IP is used. Format: “xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxx
Default is “2001:db8:2:2::”
DHCP Prefixlen Enter the Prefix length. Default is 64
DNS Server 1
Enter DNS server address 1.
The default setting is “2001:4860:4860::8888”.
DNS Server 2
Enter DNS server address 2.
The default setting is “2001:4860:4860::8844”.
If “DHCP Server” is set to “DHCPv6”
Allow IP Address From Enter the DHCP IP Pool starting address. The default setting is “2001:db8:2:2::3000”.
Allow IP Address To Enter the DHCP IP Pool ending address. The default setting is “2001:db8:2:2::4000”.
Default IP Lease Time Enter the IP lease time (in seconds). The default setting is 43200.
Table 7: GXW450X Network Settings
🡪
Basic Settings
DHCP Client List
This feature can bind MAC to IP address on the LAN port when GXW450x is set to “Route” mode.
When devices receive IP addresses from the GXW450X LAN port, they will be listed on the web UI under “System Settings 🡪 Network Settings 🡪
DHCP Client List” as shown below.
Figure 19: DHCP Client List
Users can bind manually a MAC to an IP address by clicking on , the following figure will pop up.
To Next Page
Loading...
Need help?
General
