Grandstream Networks HT801 Administration Guide

P a g e | 21
HT801/HT802 Administration Guide
Version 1.0.13.7
03
“Subnet “+ IP address
Same as menu 02
04
“Gateway “+ IP address
Same as menu 02
05
“DNS Server “+ IP
address
Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
• PCM U / PCM A
• iLBC
• G-726
• G-723
• G-729
• OPUS
• G722
10
“MAC Address”
Announces the Mac address of the unit.
13
Firmware Server IP
Address
Announces current Firmware Server IP address.
Enter 12-digit new IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address.
Enter 12-digit new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration
update. Press “9” to toggle between TFTP / HTTP /
HTTPS / FTP / FTPS. Default is HTTPS.
16
Firmware Version
Announces Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among
the following three options:
• always check
• check when pre/suffix changes
• never upgrade
47
“Direct IP Calling”
Enter the target IP address to make a direct IP call,
after dial tone. (See “Make a Direct IP Call”.)
86
Voice Mail
Access to your voice mails messages.
99
“RESET”
Press “9” to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
“Invalid Entry”
Automatically returns to main menu
“Device not registered”
This prompt will be played immediately after off hook
If the device is not registered and the option “Outgoing
Call without Registration” is in NO
Five success tips when using the voice prompt

Grandstream Networks HT801 Specifications

General

Brand	Grandstream Networks
Model	HT801
Category	Telephone Accessories
Language	English