HT801/HT802 Administration Guide
Version 1.0.13.7
Alert-Info header from server will be used. Bellcore rings and tones are
independent from custom ring tones. The custom ring tones can also be
specified by alert-info header, for example
Alert-Info: ;info=ring5
Toggles between RFC2543 hold and RFC3261 hold. RFC2543 hold allows
to disable the hold music sent to the other side, in this case IP address
(0.0.0.0) it will be sent in SDP instead of the IP address of the unit RFC 3261
(a line) will play the hold music to the other side.
Disables receiving a second incoming call when the line is engaged. Default
is No.
Disable Call Waiting Caller ID
Disables displaying caller ID when receiving a second incoming call. Default
is No.
Disable Call Waiting Tone
Disables playing call waiting tone during active call when receiving a second
incoming call. The CWCID will still be displayed. Default is No.
Disable Connected Line ID
Disables displaying the number of the person answering the phone. Default
is No.
Disable Receiver Off Hook
Tone
Enables / disables the warning to alert that the phone has been left off-hook
for an extended period of time. Default is No.
Disable Reminder Ring for
On-Hold Call
Enables playing the reminder ring. Default is No
Disable Reminder Ring for
DND
This feature allows user to disable reminder ring when FXS port is on DND
mode. Default is No
Disables use of visual message waiting indicator when there is an unread
voicemail message. Default is No.
Configures Visual WMI Type of signal sent to the analog phone to make it
turn the lamp ON upon receiving a Voice mail.
Check the phone’s manual to find out what signal is supported, FSK (default)
or NEON.
Note: Some phones (depends on the model of the analog phone) when this
feature is set to NEON it might auto ring (short beeps) when there is a voice
mail available for that FXS port where it is connected.
Do Not Escape '#' as %23 in
SIP URI
Replaces # by %23 in some special situations. Default is No.
To Next Page
Loading...
Need help?
General
