Grandstream Networks UCM6200 Series Basic Configuration Guide

P a g e | 4
UCM6200 Basic Configuration Guide
OVERVIEW
This document will provide instructions on how to set up a UCM6200 series from an out of the box state to a
fully functional state. This includes design considerations, creating user extensions, provisioning endpoints
with Zero-Config, conferencing, auto attendant configuration, analog/VoIP trunks, routing inbound/outbound
calls and voicemail/fax to email setup.
For detailed information in regard to parameters that are encountered in this guide, please check the
UCM6200 series User Manual
SETUP GUIDE SCENARIO
The image below shows the most typical setup where you have the UCM6200 series WAN port connected to
the Internet and the LAN side of the UCM6200 series providing DHCP.
We will use this scenario to setup a Grandstream GXP2135 which will be connected to the LAN side of the
UCM6200 series. There can also be a network switch connected to the LAN port of the UCM6200 series so
that there may be more than one device connected.
Figure 1: Typical UCM6200 Scenario

Grandstream Networks UCM6200 Series Specifications

General

Brand	Grandstream Networks
Model	UCM6200 Series
Category	PBX
Language	English