CE5000-UM-251-9370 2-10
2 PARTS NAMES and FUNCTIONS
(5) Attach the media guide bracket to the underside of the front panel. Loosen the two decorative screws
that are attached to the underside of the front panel (one on each side) by two or three turns, slot the
bracket in, and then tighten the screws.
Media guide bracket
Decorative screw
Pin
(6) Attach the alignment shaft to the top of the stand. Loosen the attached bindhead screws A (M4) two or
three turns, and then insert the brackets on the end of the shaft using the elongated screw holes. Tighten
the screws to hold the brackets in place. Push the shaft in until it contacts the curved area indicated by “a”
in the gure below, and then tighten the A (M4) bindhead screws.
When the shaft has been attached, tighten the bindhead screws B (M4), and check that the shaft does
not rotate. The bindhead screws B are screws to prevent the shaft from rotating. Position the shaft as
desired (check both the rotation direction and the horizontal direction) and then tighten the screws.
Bracket
a
a
a
Bindhead
screws A (M4)
Bindhead
screws B (M4)
Fixing tape
Alignment shaft
(7) Tighten all the hexagonal bolts that were temporarily fastened in step 1.
To Next Page
Loading...
