GRAPHTEC CE5000-60 - How to Replace the Rear Guide

CE5000-UM-251-9370 6-8
6 DISASSEMBLY AND REASSEMBLY
6.1.7 How to Replace the Rear Guide
How to detach the rear guide
(1) Remove the two M3L6 binding head screws from the rear guide.
(Remove the three M3L6 binding head screws from the rear guide for the CE5000-120/120AP.)
(2) Setthecamlevertothemediaholdposition.
(3) Pull out the rear guide to the rear.
M3L6 binding
head screw
How to install the rear guide
(1) Slideintherearguideandhookthenotchestotheleftandrightsideplatesasshowninthegurebelow.
(TheCE5000-120/120APhassixnotches;twonotchesfortheleftandrightsideplates,andfournotches
for the center chassis.)
M3L6 binding
head screw
Notch
Notch
Hook this rear guide notch onto the side plate.
Rear guide