GRAPHTEC CE5000-60 - How to Replace the Y-Relay Board

CE5000-UM-251-9370 6-18
6 DISASSEMBLY AND REASSEMBLY
6.2.7 How to Replace the Y-relay Board
How to detach the Y-relay board
(1) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(2) Detachthepenblockcover(seeSubsection6.2.5).
(3) DisconnectallthecablesfromtheY-relayboard.
TodisconnecttheY-exiblecable:
Removethewiringharnesstiewrapanddetachthecoreattachedwithdouble-sidedadhesivetapetothe
Y-relayboard.
(4) Removethepushrollersensorexiblecableattachedwithdouble-sidedadhesivetapetotheY-slider.
Y-relay board
M3L6 binding head screw
Core
Y-flexible cable
(5) RemovethetwoM3L6bindingheadscrewsattachingtheY-relayboard.
How to reinstall the Y-relay board
(1) ReattachtheY-relayboardinthereverseorderinwhichitwasdetached.