GRAPHTEC CE5000-60 - How to Replace the Push Roller Sensor

CE5000-UM-251-9370 6-17
6 DISASSEMBLY AND REASSEMBLY
6.2.6 How to Replace the Push Roller Sensor
How to detach the push roller sensor
(1) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(2) Detachthepenblock(seeSubsection6.2.5).
(3) DisconnectthepushrollersensorexiblecablefromtheY-relayboard.
(4) Removethepushrollersensorexiblecablethatisattachedwithdouble-sidedadhesivetapetothe
Y-slider.
(5) RemovetheM3L6bindingheadscrewattachingthepushrollersensorbrackettotheslider.
Y-slider
M3L6 binding
head screw
Push roller sensor board
Push roller sensor bracket
(6) RemovetheM3L6bindingheadscrewattachingthepushrollersensorboard.
(7) Disconnectthepushrollersensorexiblecablefromthepushrollersensorboard.
How to reinstall the push roller sensor
(1) Attachthepushrollersensorbrackettothepushrollersensorboard.
(2) Connectthepushrollersensorexiblecabletothepushrollersensorboard.
(3) AttachthepushrollersensorbrackettotheY-slider.
FitthetopandleftedgesofthepushrollersensorbrackettotheY-sliderasshowninthegurebelow.
Push roller sensor bracket
(4) Attachthepenblock(seeSubsection6.2.5).
(5) Reattachtheotherpartsinthereverseorderinwhichtheyweredetached.