CE5000-UM-251-9370 3-7
3 OPER ATIONS
• Enabling/Disabling PEN UP MOVE
This function sets whether the pen will travel to each point specied or only from the initially specied
point to the last specied point when consecutive commands are received specifying pen movement
while it is raised�
When ON is selected, the pen travels consecutively to each coordinate specied by the data received.
When OFF is selected, the pen travels directly from the initially specied point to the last specied point.
(The default setting is OFF�)
• Enabling/Disabling the Media Sensors
This function sets the media sensors that detect the size of the medium in the feed direction�
When ON is selected, the feed-direction media sensors are enabled�
When OFF is selected, the feed-direction media sensors are disabled�
(The default setting is ON�)
• Enabling/Disabling the Home Sensors
This function sets the home sensors that detect the width of the medium�
When ON is selected, the home sensors are enabled�
When OFF is selected, the home sensors are disabled�
(The default setting is ON�)
• Circle-Command Resolution Setting (when the COMMAND setting is HP-GL)
This function sets whether the resolution is automatically set or xed at a constant 5 degrees when a
cutting-plotter circle command is output while the COMMAND setting is HP-GL�
(The default setting is Auto�)
• Enabling/Disabling Blade Wear Detection
When ON is selected, the blade wear-detection setting is enabled and the blade wear-detection setting
menu is displayed in the PAUSE menu�
When OFF is selected, the blade wear-detection setting is disabled, and the blade wear-detection setting
menu is removed from the PAUSE menu and is not displayed�
(The default setting is OFF�)
• Setting the Cross-Cut Force (CE5000-120AP only)
The cross-cut force can be set in the range “1” to “31”�
(The default value is 20)
• PAUSE Key Setting
Selects the screen to be displayed when you press the (PAUSE) key while cutting or plotting�
If you select “HOLD” the cutting plotter stops cutting or plotting and displays a job select screen
prompting you to choose to continue or stop cutting/plotting�
If you select “MENU” the cutting plotter stops cutting or plotting and displays a pause menu screen�
(The default setting is MENU)
To Next Page
Loading...
