GRAPHTEC CE5000-60 - Page 51

CE5000-UM-251-9370 6-13
6 DISASSEMBLY AND REASSEMBLY
(7) Detach the right side cam shaft holder.
Cam shaft
Cam
Right cam shaft holder
(8) Pull out the cam shaft from the right side.
(9) Detachthepushrollerarmspringfromthepushrollerarm.
(10) DetachtheE-ringfromthepushrollerarmshaft.
E-ring
Push roller arm shaft
(11) Detachthepushrollerarmshaftfromthepushrollerarmanddetachthepushrollerarm,pushrollerarm
base,andthecam.
How to reinstall the push roller arm
(1) SpreadasuitablequantityoftheShinetu silicon grease G501 on the cam as shown below.
Spread a suitable quantity of
silicon grease on this part.
(2) Reattachthepushrollerarminthereverseorderinwhichitwasdetached.