GRAPHTEC CE5000-60 - Page 72

CE5000-UM-251-9370 6-34
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the main board (Old type)
(1) Reattach in the reverse order in which it was detached.
(2) Installthemainboardcorrespondingtoeachmodelwhenreplayingtothenewmainboard.
(3) Ifyouhave“BOOTSTARTERROR”whenyoureplacedthemainboard,Installthermwarefornew
main board (see Section 7.10).
(4) Performanyadjustmentsrequired(seeSection7.2).
How to reinstall the main board (New type)
(1) Setthedipswitch1ofmainboardforcorrespondedmodelasshownintablebelow.
DipSwitch 1 2 3 4 Model
SW1
1234
ON
OFF
OFF OFF OFF OFF CE5000-40CRP (Craft ROBO Pro)
SW1
1234
ON
OFF
ON OFF OFF OFF CE5000-60
SW1
1234
ON
OFF
OFF ON OFF OFF CE5000-120
SW1
1234
ON
OFF
ON ON OFF OFF CE5000-120AP
(2) Reattach in the reverse order in which it was detached.
(3) Ifyouhave“BOOTSTARTERROR”whenyoureplacedthemainboard,Installthermwarefornew
main board (see Section 7.10).
(4) Ifyouhave“NV-RAMERROR”whenyoureplacedthemainboard,performtheNV-RAMClearfornew
main board (see Section 7.4).
(5) PerformtheNV-RAMClearwhenthedipswitchsettingwaschanged.
(6) Performanyadjustmentsrequired(seeSection7.2).