GRAPHTEC CE5000-60 - Page 98

CE5000-UM-251-9370 7-16
7 ELECTRICAL ADJUSTMENTS
(7) For old type of main board:
When the upgrading is complete, the plotter will start the initialization routine.
Whenyouinstallthermwareforthersttime,modelselectmenuappears,soselectthemodelatthis
time.
For new type of main board:
When the upgrading is complete, the following menu is displayed and then perform the NV-RAM Clear
for the each model.
Flash NV ERROR
(8) Thermwareversionisdisplayedduringtheinitializationroutine.Checkthermwareversionthatyou
upgraded.
(9) Turn off the power.