2 – 6
Place the roll medium on the stand stock rollers, and then pass the leading edge of the medium from the
back of the cutting plotter so it emerges from the front, while making sure to remove any slack in the
medium conveyance path.
Pull the leading edge out of the front of the cutting plotter so that it completely covers the media sensor. If
the leading edge has been pulled out too far, turn the roll to adjust the length of the medium that is protrud-
ing.
Adjust the position of the left- and right-hand push rollers to suit the width of the roll medium.
Step
2
Step
3
Load the medium so that it passes over the media sensor.
Step
4
* The illustration below is of the CE5000-120 model.
Media sensor
* The illustration below is of the CE5000-120 model.
CHECKPOINT
To Next Page
Loading...
