4 – 7
Press the (ENTER) key or use the key to move the cursor to the right-hand side, and then press
the key again to display the menu shown below. If the distance adjustment is set for the setting area
selected, the distance adjustment will be displayed here. Either press the (ENTER) key or move the
cursor to the right-hand side and press the key.
Press the or key to select “Mode 1” or “Mode 2,” and then press the (ENTER) key. The over-
cut setting is displayed.
“STR” indicates the initial overcut amount, and “END” indicates the end overcut amount for the line sec-
tion. Press the or key to select “STR” or “END”, use the or key to increase or decrease the
values, and then press the (ENTER) key to confirm. To cancel the selection(s), press the (NEXT) or
(PREV.) key.
Step
6
Step
7
Step
8
TANGENTIAL MODE 1
STR=0.2 END=0.2
To Next Page
Loading...
