GRAPHTEC CE5000-60 - Page 61

4 – 17
Press the (PAUSE) key to cancel PAUSE mode.
This adjusts the position of the sensor for the reading of registration marks. The adjustment crosshairs are
plotted after crosshairs already plotted have been read, and the difference between the two is input to
adjust the position.
Load a medium with the crosshairs plotted.
Set the cutter pen conditions to “PEN” (refer to “3.3 Setting the Cutter-Pen Condi-
tions”), and mount a pen in the cutting plotter.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then
press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key. The following menu is displayed.
Use the , , , and (POSITION) keys to move the cutter pen to the
position of the crosshairs already plotted on the medium, and then press the
(ENTER) key. The sensor scans the crosshairs and overwrites them.
Step
6
Adjusting the Registration-Mark Reading Sensor (1)
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
7
MARK MODE
MARK POSITION
MARK TYPE
MARK SIZE
MARK DIST. ADJ.
MARK OFFSET
MARK SENSOR ADJ1
MARK SENSOR ADJ2
MARK AUTO SCAN
MARK SENSOR ADJ
Medium feed
direction
Move the pen
within this area
Medium feed
direction
Crosshairs already
plotted
Newly plotted crosshairs
Crosshairs already plotted
Distance adjustment Y
Distance
adjustment X
X
Y
X
Y
AUTO REG. MARK
MARK SENSOR ADJ1
MARK ADJ1 SCAN