13
CAUTION
Do not touch the Tool edge when power is
turned on or or during operation.
Supplement
See "Structure of Cutter Plunger" for
bladelength adjustment knob.
6 As instructed, turn the blade length adjustment knob to the left to fully
retract the blade.
Blade
Supplement
Adjustment is only possible for the cutter pen
set in Tool Holder 1 (Backward). It does not
apply to Tool Holder 2 (Forward).
See "Attaching a Tool" for instructions on
setting.
7 Set the cutter Plunger in Tool Holder 1 (Backward).
8 Press the [ENTER] key.
You can calculate the height by moving the tool up and down.
TO ACHIEVE THE TARFET LENGTH screen is displayed.
9 Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen (TARGET) is displayed.
10 Press the POSITION ( ) key and increase or decrease the setting value.
11 Conrm the settings and press the ENTER key (SET).
The Blade Length Target will be selected, and you will return to the TO
ACHIEVE THE TARGET LENGTH screen.
Supplement
"T" is the target value of the blade length, and
"H" is the current blade height (amount).
Turning the blade-length adjustment knob
displays the number of turns and direction.
12 Press the [2] key (CHECK).
You can calculate the height by moving the tool up and down.
The amount and direction to turn the adjustment knob is displayed.
CAUTION
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
13 Turn the blade-length adjustment knob and adjust the cutter blade length.
[2] Current blade length is displayed by pressing the [2] key (CHECK) , so
adjust the blade length until it matches the thickness of the media.
14 Press the [3] key (END).
Adjustment is completed and it will return to CONDITION screen (3/3).
15 Press the [COND/TEST] key.
I will be return to default screen. After completing the settings, press [ENTER] key.
To Next Page
Loading...
