5
3 Push the tip of the roll media forward from the back of the CE6000.
Make sure to pull it so that there is no slackening across the roll media's
route.
When using the roll media tray
Put the roll media on the roll media tray and
then push the tip of the roll media forward from
the back of the machine.
Media stopper
This stops the stock shaft from spinning when
setting in media. It is also utilized when pulling
roll media straight out.
4 Press the media stopper to engage it, and then pull the leading edge
out of the front of the plotter, making sure that it completely covers the
media sensor.
Media sensors
Slide the
media
stopper
Media stopper
Supplement
When actually cutting, please release the lock
from the media stopper (while pulling to the
exterior, slide it forward).
5 Position the media and the push rollers to correspond with the width of
the media.
When using the model with 2 push rollers
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers" about the
position of the push rollers.
The push rollers push down on either side of the media. Use the grit
roller position guide to make sure the push rollers are set on top of the
grit rollers.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
To Next Page
Loading...
