6
When using the model with 4 push rollers
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers" about the
position of the push rollers.
•
See "Aligning the Push Rollers" for
information about push roller hold-down
force.
Use the 4 push rollers to push down the sides and center of the media.
Use the grit roller position guide and make sure the push rollers are on
top of the grit rollers.
You can adjust the center push roller's hold-down force.
Grit roller position guide
Media sensor
Push roller
Grit roller
Push roller
(The center push roller is not on top of the
grit roller.)
(The center push roller is near the edge.)
(The push roller is on top of the grit roller.)(The push roller is on top of the grit roller.)
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
Media
15mm 15mm
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of the media.
Push roller
Media
5mm 5mm
6 Pull the media taut to make sure that there is no slack in the conveyance path, and then raise the media set lever to
lower the push rollers.
Media set lever
To Next Page
Loading...
