FC7000-UM-251-9370 3-7
3. OPERATIONS
• Enabling or Disabling the 1/2 Pen Setting (CHECK PEN)
Note: This function can only be specified for a 2-pen model.
This function checks whether the physical PEN 2 is actually mounted in the pen station during the media
detection operation on a 2-pen model.
When ENABLED is selected, a check is performed
When DISABLED is selected, a check is not performed. If DISABLED is selected, always check that
PEN 2 is mounted in the pen station before turning on the power.
• Fan Suction Setting (FAN POWER)
This function sets the suction force used to affix media to the plotter.
Thin media: Weak
Normal media: Normal
• Enabling/Disabling the Beep Setting (BEEP FOR KEY OPERATION)
This function selects whether to enable or disable the beep that is emitted whenever a control panel key
is pressed.
ON: The beep sounds.
OFF: The beep does not sound.
• Enabling/Disabling Auto Registration Mark Recognition (MARK AUTO SCAN)
This function enables or disables the automatic sensing of registration marks from the plug-in software.
ON: The registration marks are sensed automatically.
OFF: The registration marks are not sensed automatically.
CAUTION: If DISABLED was selected for the media or pinch roller sensors, be sure
to specify the cutting or plotting area. If the cutting or plotting area is not
specified, the blade tip and the cutting mat may be damaged, and the pen
carriage may strike the sides of the plotter.
To Next Page
Loading...
